Agilent 5991-2906EN Strain-Rate Sensitivity of Thin Metal Films by Instrumented Indentation - Application No free download

File name 5991-2906EN Strain-Rate Sensitivity of Thin Metal Films by Instrumented Indentation - Application No

Keysight Technologies Strain-Rate Sensitivity of Thin Metal Films by Instrumented Indentation Application Note Introduction Strain-rate sensitivity (SRS) is an important material property, because it quantifies the tendency of the material to creep. Materials which do not creep have a near-zero strain-rate sensitivity. For materials with high strain-rate sensitivity, small stresses can cause plastic deformation, if the strain rate is sufficiently small. In this note, we present a new technique for measuring strain-rate sensitivity by instrumented indentation. This new technique is insensitive to thermal drift and can be used for thin films and other small volumes [1, 2]. We demonstrate the technique by using it to measure the strain- rate sensitivity of thin copper and nickel films deposited on silicon, and we compare our results to those that have been published for comparable materials. Maier et al. mea- sured the strain-rate sensitivity of ultra-fine-grained nickel by instrumented indentation to be 0.019, and they compared this value to the results of uniaxial testing on the same material which gave a value of 0.016 [3]. Ye et al. consolidated strainrate sensitivity measurements that have been published for copper and presented them as a function of grain size [4]. For grain sizes on the order of 100nm